Any-Weigh™ Series Floor Scales
3
out. The active elements of the floor scales are four
precision strain gauge load sensors, mounted on all
four corners of the scale platform. The unique Blind
Hole Load Introduction technology allows the foot to
move to compensate for uneven floors. This ensures
that the load forces are always applied to the load sen-
sor at precisely the same point regardless of where the
load is placed on the scale. This ensures you will get
accurate and repeatable weighments.
Each platform load sensor is initially certified for use
in a C2
®
Second Generation Calibration system.
UNPACKING
The Any-Weigh Series Floor Scales are shipped fully
assembled and wired. Inspect the container for any
signs of damage that might occur during shipment.
Since almost all of the Floor Scales are shipped
F.O.B. factory, such damage is normally the responsi-
bility of the carrier and should be reported to them.
Step 1.
Remove the banding straps and any ship-
ping restraints.
WARNING
DO NOT USE HOOKS OR UNCLOSED EYE-
BOLTS OR ATTEMPT TO LIFT THE SCALE
MANUALLY. FAILURE TO USE THE PROPER
LIFTING TOOLS OR LIFTING METHODS CAN
CAUSE PERSONAL INJURY OR PROPERTY
DAMAGE.
Step 2.
Screw 2 closed eyebolts into the threaded
holes on the top plate of the scale. (See
Fig. 1)
•
Mild Steel - 1/2 - 13 x 1.5” (Hardy Model
Number HI EB2250-1)
Step 3.
Attach a chain, cable or nylon strap to the
eyebolts.
Step 4.
Use a forklift or crane with rated lifting
capacity that is equal to or greater than the
total weight of the platform scale to lift the
scale high enough to remove from the
Summary of Contents for Any-Weigh
Page 4: ......
Page 8: ...Any Weigh Series Floor Scales II ...
Page 52: ...Any Weigh Series Floor Scales ...
