Any-Weigh™ Series Floor Scales
31
Step 5.
Tap the anchor bolt into the hole then
tighten the nuts securely.
Step 6.
Lift the Platform out and away form the
bolt-down plate.
Step 7.
Drill the two (2) inner holes using a ham-
mer drill. (See Specifications/Anchor Bolt
Holds above for hole dimensions)
Step 8.
Insert the anchor bolts with the nut and
washer already ON.
Step 9.
Tap the anchor bolts into the hole then
tighten the nuts securely
Step 10.
Note the following:
•
If two ramps are installed, NO other bolt-
down plates are needed
•
If one ramp is installed then a set of two bolt-
down plates are needed.
•
Only two ramps total may be installed on
opposite sides of a scale platform.
OPTIONAL BOLT-
DOWN PLATES
Bolt down plates are used to keep the scale from slid-
ing or moving when loads are applied. The plates are
bolted via anchors at each of the scales feet. (See Fig.
27)
Kit
Model Numbers
Stainless
Mild Steel
4 Plates
8 Bolts
HI ABDP1-3
HI ABDP1-1
2 Plates
4 Bolts
HI ABDP2-3
HI ABDP2-1
Table 7: Bolt Down Plates and Anchor Bolts
Summary of Contents for Any-Weigh
Page 4: ......
Page 8: ...Any Weigh Series Floor Scales II ...
Page 52: ...Any Weigh Series Floor Scales ...