HARDY MANUFACTURING CO., INC (MODEL LC300, LC500 & LC2500)
PAGE 50
8-5
Draft Blower Replacement Instructions (continued)
Step
Operation Description
Visual Aids/Comments
6
Install damper lifting ring into the damper lid as shown.
7
Using a 5/16" wrench or other suitable tool, remove the
cover from the blower electrical box and set aside.
Using pliers or other suitable tool, remove the right
knockout and install the plastic romex connector.
8
Push blower power wires through connector. Replace
blower electrical box cover. Using pliers press the
wedge clamp into place.
9
Connect power wires and install plastic cable tie if
available.
10
Verify blower is firmly attached to flange and damper
flapper will lift freely.
11
Reconnect power to furnace.
!
Hazardous Voltage! Disconnect Power to
Heater prior to performing this
maintenance operation.
Summary of Contents for LC2500
