my
HARGRAY
DVR
USER GUIDE
28
Setting HDMI and Component Output Resolution
You can select 1080i, 720p, 480p or 480i on the HDMI and Component output. When
you set the output, both HDMI and Component outputs are set to the selected resolu-
tion, the “HD” indicator in front panel will glow in blue if the resolution is set to 720p
or higher. The RCA Composite and RF outputs are always set to 480i and will not be
affected by the HDMI and Component resolution setting. The resolution can be set in
the User Menu or the middleware. Please refer to the section “User Menu” on chang-
ing settings in the User Menu.
NOTE:
If your TV does not display the video or error message is displayed after you
have selected a new resolution, your TV may not support the selected resolution. Re-
fer to your TV owner’s manual for verification. Repeat the above procedures again to
find a resolution supported by your TV.
Setting channel ID
In “RF TV”, channel 3/4 is used by default. You can change the channel ID by toggling
the CH3/CH4 switch at the rear panel.
NOTE:
The new channel ID will take effect immediately after the switch is toggled.