14
D. THE GAS SYSTEM
GAS AND REGULATOR INFORMATION
This smoker is designed for universal liquid propane
gas (ULPG) use only. Gas bottles with a “POL” low
pressure connection are to be used with this smoker
Suitable regulators must have an outlet pressure
of 2.75 kPa. You must have the proper regulator
and bottle in order for the smoker to operate
safely and efficiently. Ensure that a 100% universal
propane refillable gas (ULPG) cylinder currently
certified to Australian Standard AS2030.1:2009 is used.
Do not use disposable gas cylinders. Please note the
hose and regulator supplied with this smoker are of an
approved type and are specifically designed for use
with your smoker.
CONNECTING THE HOSE AND REGULATOR TO THE
GAS BOTTLE
• This appliance is not intended to be connected to
household or consumer piping.
• Only use the hose and regulator assembly supplied
with this appliance for direct connection to the gas
cylinder – DO NOT USE ADAPTORS.
• Check the gas hose for any damage or signs of
abrasion before each use.
• Keep the hose clear of sharp edges and hot
surfaces.
• Avoid twisting or kinking the flexible hose.
• If damaged, do not use the hose and replace it
immediately. If there is any doubt, contact the
customer service line on 1300 799 787.
• Check the gas cylinder control knob is in the off
position. To turn off it should be turned clockwise
to a full stop.
• Check the control knob on the smoker is in the off
position.
• Hold the regulator in one hand and insert the
nipple into the gas bottle outlet. Be sure the nipple
is centered in the outlet. Use care not to cross
thread the connection.
• Hand tighten the coupling nut anti clockwise until it
comes to a firm stop.
• Firmly tighten by hand only. Do not use tools.
BE SURE TO CHECK FOR LEAKS AT ALL
CONNECTIONS
DANGER
ALL INSTRUCTIONS AND SAFEGUARDS
MUST BE FOLLOWED TO PREVENT FIRE, PROPERT Y DAMAGE, OR PERSONAL INJURY.
