DIAGRAM 21.
Locked (left): Single Black/Red Hoisting Rope
(F) pointed straight down locks cleat. Open (right): Angled
rope opens cleat. Larger system shown.
LOCKED:
Rope (F) down
OPEN:
Rope (F) angled
STEP 6: OPERATING HOISTER SYSTEM
LOCKED
LOWERING:
(Cleat Open)
Tip:
Use gloves to protect hands.
WARNING! Disable garage door opener when
installing, raising, or lowering the Hoister. Do
not raise or lower with anyone standing under
object. Keep area below Hoister clear. If the
load falls it may cause an accident.
WARNING! Hang coiled rope where it will not
accidentally snag on persons or vehicle. Keep
coiled rope out of reach of children. Damage or
injury may result if rope is angled away from wall
with some tension; the object can come down
very quickly which may cause an accident.
WARNING! When operating system, make sure
area below object is clear of persons. If object
comes down too quickly this may cause an
accident.
WARNING! Stop pulling as soon as object
contacts ceiling or webbing strap knots stop at
pulley (D). Damage or injury may result from
forcing the system. If in doubt, stop hoisting,
allow cleat to lock by angling rope down. Stand
back to see if object is raised to the maximum
or if something is jamming rope or object.
CAUTION! Avoid injury, do not let rope slip
through hands. Angle rope to wall to lock rope.
WARNING! This product is not to be used for
human suspension. Components may fail
causing person to fall, possibly resulting
in serious injury or death.
With rope pointed down the cleat will lock the rope
and you can release it. Repeat until object is at
desired height.
A. RAISE OBJECT
Hoist in a series of pulls. Pull Single Black/Red Hoisting
Rope (F) straight down.
B. STORE OBJECT
With object in raised position make sure Single Black/
Red Hoisting Rope (F) is securely locked in cleat with rope
pointed down (see Diagram 21). Coil loose rope end.
Tip:
For additional security, use two 5/16" (8 mm)
polyester safety ropes. Securely tie ends to pigtail lag
screws under object, parallel with Webbing Straps (E).
Remove safety ropes before lowering object.
C. LOWER OBJECT
Securely grip rope, apply tension and angle it away
from front wall. Bring arm up to let rope out and then
back towards the wall to lock the rope. Repeat until
object is at desired height.
