Install Blocks on Toggle
Tools
• 2 small slotted screwdrivers
1
/
4
" (6 mm) clevis pin only
• Needle-nose pliers
5
/
16
" (8 mm) Clevis Pin
1. Remove block shackle.
Insert block. Insert
5
/
16
"
(8 mm) clevis pin through
toggle and secure with
cotter pin.
5. Insert stand-up device so
large flat end of rubber is
up. Press down and push
pivot pin into place.
6. Secure with set screw
or swivel ear screw.
Reassemble control
blocks using blue
Loctite
®
on screws.
Note:
Use Loctite
®
on
stainless screws only.
Do not use on plastic
set screws.
Install Toggle on Car
Tools
•
Small slotted screwdriver
•
Icepick
•
Phillips screwdriver
1. Remove control blocks,
or windward assembly.
2. Remove two (2) plastic
set screws located on
top of car.
Cars with swivel ears will
not have plastic set screws.
3. Use icepick to push pivot
pin to one side and
remove shackle.
*1994, 669 includes H-30392B adapter
post to fit 100 mm blocks and 75 mm
double and spriddle.
4. Install one (1) plastic set
screw so it is flush with
top of car.
Cars with swivel ears:
Install one (1) swivel ear
and screw using thread
locking solution on screw.
Install Control Blocks on Toggle
1950, 1951, 1952, 1954,
1959
and
1960
blocks
attach using shackle
and becket spacer.
No.
Description
Part No.
598/669*
1 Large cotter pin
HFS181
2
5
/
16
" (8 mm) clevis pin
H-21164A
3 BB stand-up toggle
H-29133C
4 Polyurethane stand-up device MP-1839
5
1
/
4
" (6 mm) clevis pin
H-29157A
6 Becket spacer
H-29681A
7 Split ring
MS-011
8 Blue Loctite
®
833
9 Replacement set screw
HFS1050
1 2
3
4
5
5
6
6
7
7
8
9
9
