28
CLR Mooring Winch
Installation and Maintenance Manual - Mod.A
Connect here led lights*
Do not use DSS
Connect here led lights*
Cabling with DSS
Cabling with BRS
*
NOTE!
User can choose if installing led lights with a switch or not: if led lights are installed with the switch, their
power-up and power-off states are commanded by the switch. In those cases, even if the winch is not
used, lights can be lighted or switched-off.
If lights are installed without switch, their control is commanded by the HCP switch. In this case, connect
the led lights in correspondence of the point shown in the wiring diagrams above.
8.2 Electric wiring diagrams - Dual Function Control Box (DFCB)
To guarantee greater efficiency in terms of safety and long life, for every winch model is mandatory to
install the Dual Function Control Box.
Refer to the following diagrams for the electric wiring:
WARNING!
Read the Dual Function Control Box manual carefully before installing and using the device.
Fasten the Dual Function Control Box containing solenoids to bulkhead or wall: refer to the
Dual Function Control Box manual. Install remote circuit breaker between power supply
and Dual Function Control Box. Locate the electric buttons on deck in a convenient spot for easy
winch operation: refer to the Digital System Switch manual.
