8
Performa
™
Winch
50.2 STP EL/HY
Installation and Maintenance Manual - Mod.D
Winch installation procedure
Carry out the
Procedure
, then install the winch on the deck in the chosen position.
NOTICE
Before drilling the deck, check the space available below deck for the flange and the motor
A.
Position the base of the winch on the deck and mark the position of the holes or use the drilling
cut-out template at the point where you have decided to place the winch.
Below is a reduced scale diagram.
The drilling cut out template is available on the Harken
®
website, www.harken.com
B.
Remove the winch and drill the five 6.2 mm diameter holes.
C.
Bolt the base of the winch to the deck using five M6 Socket Head (SH) bolts (no supplied by
Harken
®
), correctly chosen for the thickness and type of the boat deck. Consult the yard that built the
boat in case of doubt.
WARNING!
To install the winch on the deck, use only bolts in A4 stainless steel (DIN 267 part11).
Bolts made of other materials may not have sufficient strength or may corrode which can
result in winch pulling off deck suddenly and unexpectedly during high loads causing
severe injury or death.
NOTICE
To mount winches on the deck, do not use countersunk bolts.
D.
Fill the mounting holes with a suitable marine sealant.
E.
Remove the excess adhesive/sealant from the holes and base drainage channels
F.
Reassemble the winch following the steps of the
Procedure
in the reverse order, and apply the
products indicated in the section on maintenance
.
final pinion
position
¯80 cut out for
powered winches
¯150
46¡
46¡
64¡
70¡
70¡
64¡
Winch outside ¯194
