Thomann GmbH • Hans-Thomann-Straße 1 • 96138 Burgebrach • www.thomann.de • info@thomann.de
DocID: 425040_20.05.2021
Using the product
1. To avoid interference, do not operate the device near other wireless devices,
such as WiFi routers or the like.
2. Fully charge the transmitter and receiver batteries prior to initial use using the
Duo-pin USB charging cable. When the device is switched off, the LEDs indicate
the loading progress.
Duo-pin USB charging cable
When the device is switched on, the LEDs light up to indicate the charging
process. If a low battery is displayed, there will be approximately 10 minutes left
to run. At the latest then the built-in battery must be charged.
. Fold the plug into a position suitable for the desired use:
Plug the transmitter into the 1/4" phone socket of the instrument whose signal
you want to transmit. The transmitter flashes five times. During transmission,
the LED indicator lights up.
4. Plug the receiver into the 1/4" phone input of an amplifier or effects unit. The
receiver flashes five times. If the data transmission is stable, the LED indicator
lights up constantly. If the signal is too weak, the LED flashes. Then reduce the
distance between transmitter and receiver.
5. To switch on transmitter and receiver, set their on / off switches in the ON
position.
6. Select the same transmission channel for transmitter and receiver by pressing
the channel selection button. The default setting at power up is ‘Channel 1’. We
recommend using this channel if there is no radio interference. Otherwise, try
operating on a different channel.
7. The transmission signals can be received by several receivers. Thus, for example,
the signal can be fed to 2 amplifiers simultaneously and a stereo sound image
can be generated.
8. To switch off transmitter and receiver, set their on / off switches in the OFF
position.
EN
For the transport and protective packaging, environmentally friendly materials
have been chosen that can be supplied to normal recycling. Ensure that plastic
bags, packaging, etc. are properly disposed of. Do not just dispose of these ma-
terials with your normal household waste, but make sure that they are collected
for recycling. Please follow the notes and markings on the packaging.
Batteries must not be thrown away or incinerated; they must be disposed of in
accordance with local regulations for the disposal of hazardous waste. Use the
existing collection points for this.
Dispose lithium batteries only in discharged condition. Remove replaceable
lithium batteries from the device before disposal. Protect used lithium batter-
ies from short circuits, for example by covering the poles with adhesive tape.
Permanently installed lithium batteries must be disposed of together with the
device. Please inquire about a suitable acceptance point.
This product is subject to the European Waste Electrical and Electronic Equip-
ment Directive (WEEE) in its currently valid version. Do not dispose of your old
device with your normal household waste. Dispose of this product through an
approved waste disposal firm or through your local waste facility. Comply with
the rules and regulations that apply in your country. If in doubt, consult your
local waste disposal facility.
AirBorne Wi-2.4-GHz instrument
Technical specifications
Receiver
Frequency of operation
2.400 GHz … 2.485 GHz
Transmission channel
4
Audio samling rate
24 bit / 48 kHz
Output impedance
2 kOhm
Frequency range
20 Hz … 20 kHz
Latency
< 5 ms
Power supply
via USB port
Battery
Type
Lithium ions battery
Voltage
3.7 V
Capacity
500 mAh
Operating time
6 h
Charging time
2 h
Dimensions (W
×
H
×
D)
73 mm × 40 mm × 15 mm
Weight
50 g
Ambient conditions
Temperature range 0 °C ... 40 °C
Relative humidity
20 % ... 80 %
(non-condensing)
Transmitter
Frequency of operation
2.400 GHz … 2.485 GHz
Max. Sendeleistung
110 dBm
Audio samling rate
24 bit / 48 kHz
Input impedance
1 MOhm
Range (free field)
30 m
Latency
< 5 ms
Power supply
via USB port
Battery
Type
Lithium ions battery
Voltage
3.7 V
Capacity
500 mAh
Operating time
6 h
Charging time
2 h
Dimensions (W
×
H
×
D)
73 mm × 40 mm × 15 mm
Weight
50 g
Ambient conditions
Temperature range 0 °C ... 40 °C
Relative humidity
20 % ... 80 %
(non-condensing)
