background image

- 4 -

cuit or an electrical shock. Do not place the device, speaker cabinets or any

-

thing else on the power cord and make sure that it does not become clamped. 

Place the power cord in a position where it can not be trod on. A damaged 

power cord can cause a fire or an electrical shock. Check the power cord from 

time to time. Should it become damaged contact our customer service centre 

to have it replaced.

   Risk of fire!

NEVER leave the device unattended while it is switched on.

• 

Never cover the fan or the ventilation slots of the device while it is switched 

• 

on. Avoid placing this device in locations that provide insufficient ventilation or 

hot locations and do not place the device in direct sunlight or under strong 

artificial light sources. Otherwise, it may overheat and become irreparably 

damaged.

Do not place any open sources of fire, like candles, on the device.

• 

When a thunderstorm with the risk of lightening threatens please disconnect 

• 

the device from the mains power.

  Risk of personal injury!

Keep the power cord and device away from children. Children frequently un-

• 

derestimate the dangers of electrical equipment.

Ensure a safe location for the device.

• 

Do not operate the device if it has sustained a fall or is damaged. Arrange for 

• 

the device to be checked and/or repaired by qualified technicians.

WARNING:

This symbol, wherever it appears, alerts you to the presence of 

uninsulated dangerous voltage inside the enclosure--voltage that 

may be sufficient to constitute risk of shock.

This symbol, wherever it appears, alerts you to important operating 

and maintenance instructions in the accompanying literature. Read 

the manual.

Summary of Contents for HB 3000 BT













Reviews: