Thomann GmbH • Hans-Thomann-Straße 1 • 96138 Burgebrach • www.thomann.de • info@thomann.de
DocID: 523016_08.07.2021
PowerPlant
ISO-3AC SAG Modular
EN
For the transport and protective packaging, environmentally friendly ma-
terials have been chosen that can be supplied to normal recycling. Ensure
that plastic bags, packaging, etc. are properly disposed of. Do not just dis-
pose of these materials with your normal household waste, but make sure that they
are collected for recycling. Please follow the notes and markings on the packaging.
This product is subject to the European Waste Electrical and Electronic
Equipment Directive (WEEE) in its currently valid version. Do not dispose of
your old device with your normal household waste. Dispose of this product
through an approved waste disposal firm or through your local waste facil-
ity. Comply with the rules and regulations that apply in your country. If in doubt,
consult your local waste disposal facility.
Using the product
1. To put the device into operation, use the supplied power cord to connect the
INPUT connector on the side of the device to a properly wired power socket,
that provides 100 – 240 V supply voltage .
2. Use suitable voltage supply cables to connect effect pedals or similar devices
which require 4 to 9 V supply voltage at a maximum of 500 mA to outputs
1 – 2. Before doing so, set the associated rotary control to the position of the
required voltage. The maximum output power of 21.6 W must not be
exceeded.
Danger of property damage by polarity reversal
Make sure that the polarity of the devices to be connected must be
the same as the polarity of the power supply outputs (
).
To power a device with polarity-reversed voltage may damage it!
Danger of property damage by overvoltage
Make sure that connected devices are actually suitable for the set
voltage. To power a device with overvoltage may damage it!
3. Use suitable voltage supply cables to connect effect pedals or similar devices
which require 6 – 18 V supply voltage at a maximum of 500 mA to outputs
3 – 4. Before doing so, set the associated rotary control to the position of the
required voltage. The maximum output power of 21.6 W must not be exceeded.
4. Each operational output is indicated by a green LED. If an output is switched
off due to overload, the LED lights turns off. Then disconnect the pedal in
question from the device. After approx. 2 seconds, the normal voltage supply
is restored here.
5. To supply another device with mains voltage use the supplied Kettle cable to
connect its mains power connection to the OUTPUT connector on the side of
the device.
6. To switch off the device, disconnect the power cord from the mains.
