Thomann GmbH • Hans-Thomann-Straße 1 • 96138 Burgebrach • www.thomann.de • info@thomann.de
DocID: 520988_19.09.2022
EN
Spaceship Power 80-B
Using the product
1. Use the supplied power adapter to connect the device to the power and press
the mains switch to switch on the device.
2. Use a suitable voltage supply cable to connect effects pedals or similar devices
which require 24 V supply voltage at a maximum of 2000 mA to the output 1.
3. Use a suitable voltage supply cable to connect devices with high power
consumption (i. e. multi-effect devices) which require 9 V supply voltage at
a maximum of 3000 mA to the output 2.
4. Use suitable voltage supply cables to connect effects pedals or similar devices
which require 9 V supply voltage at a maximum of 250 mA to the
outputs 3 - 6.
5. Use suitable voltage supply cables to connect effects pedals or similar devices
which require 9 V supply voltage at a maximum of 500 mA to the
outputs 7 - 9.
Danger of property damage by polarity reversal
Make sure that the polarity of the devices to be connected must be
the same as the polarity of the power supply outputs (
). To
power a device with polarity-reversed voltage may damage it!
6. Use suitable voltage supply cables to connect effects pedals or similar devices
which require 9 V ,12 V or 18 V supply voltage at a maximum of
500 mA, 375 mA or 250 mA to the outputs 10
-
13. Set the associated switch
above the output to the position of the required voltage. The maximum output
power of 45 W must not be exceeded.
7. Use suitable voltage supply cables to connect devices as smartphones or
tablets to the USB outputs.
8. Each operational output 1
-
13 is indicated by a green LED. If an output is
switched off due to overload, the LED turns off. Then disconnect the respective
pedal from the device. After approx. 2 seconds, the normal voltage supply is
restored here.
9. Press the mains switch to switch off the device.
Danger of property damage by overvoltage
Make sure that connected devices are actually suitable for the set
voltage. To power a device with overvoltage may damage it!
Technical specifications
• Connections (
)
- Output 1
24 V @ max. 2000 mA
- Output 2
9 V @ max. 3000 mA
- Outputs 3
-
6 9 V @ max. 250 mA (individually insulated)
- Outputs 7
-
9 9 V @ max. 500 mA (individually insulated)
- Outputs 10
-
13
switchable 9 / 12 / 18 V @ max. 500 / 375 / 250 mA
(individually insulated)
• USB output
USB-C max. 18 W
USB-A max. 18 W
• Power output
45 W
• Current output
4050 mA
• Power supply
External power adapter, 100 - 240 V ~ 50/60 Hz
• Operating voltage
24 V / 2 A, centre negative
• Battery
Battery type
Lithium-ion
Voltage
7.4 V
Capacity
9000 mAh
Operating time
1.1 h (after 3.4 h charging time)
• Dimensions (W × H × D)
800 mm × 89.5 mm × 390 mm
31.50" × 3.52" × 15.35"
• Weight
3230 g
• Ambient conditions
Temperature range 0 °C...40°C
Relative humidity
20 %...80 %
(non-condensing)
For the transport and protective packaging, environmentally friendly materials
have been chosen that can be supplied to normal recycling. Ensure that plastic
bags, packaging, etc. are properly disposed of. Do not just dispose of these ma-
terials with your normal household waste, but make sure that they are collected
for recycling. Please follow the notes and markings on the packaging.
Only dispose of lithium batteries when they are discharged. Remove replaceable
lithium batteries from the device before disposal. Protect used lithium batteries
against short circuits, for example by covering the poles with adhesive tape. Per-
manently built-in lithium batteries must be disposed of together with the device.
Please inquire about an appropriate collection point.
This product is subject to the European Waste Electrical and Electronic Equip-
ment Directive (WEEE) in its currently valid version. Do not dispose of your old
device with your normal household waste. Dispose of this product through an
approved waste disposal firm or through your local waste facility. Comply with
the rules and regulations that apply in your country. If in doubt, consult your lo-
cal waste disposal facility.
