Harman Kardon Cen-TS20/30, Service Manual

6

5. If you’re not running the speaker wire through the wall, insert  

    it through the wall portion of the wall-mount bracket as  

    shown in the illustration.

6. Pass the speaker wire through the speaker portion of the 

    wall-mount as shown in the illustration.

Bring Wire In

through Here

Bring Wire Out

through Here

7. If you have not already removed the speaker’s base, do so by 

    pulling it straight off the speaker, as shown in the illustration.  

    Applying even pressure to both sides of the base will allow it 

    to slide off smoothly.

   CAUTION: Before making speaker connections, be sure that 

   your receiver or amplifier is turned OFF and preferably, 

   its AC cord is unplugged from the AC outlet.

Apply Pressure Evenly

to Both Sides of Base

Lift Base Straight

off Speaker

8. Connect the speaker wire to the speaker terminals as shown in 

    the illustration: 
    a) Press down on the top of the terminal to open the connection hole.

    b) Insert the wire’s bare end all the way into the hole.

    c) Release the terminal to secure the wire. 
    Insert the conductor with the colored band into the speaker’s 

red

 ( + ) terminal, and insert the other conductor into the speaker’s 

black

 ( – ) terminal.

IMPORTANT: Make sure the ( + ) and ( – ) bare wires do not touch 

each other or the other terminal. Touching wires can cause a short 

circuit that can damage your receiver or amplifier.

+

–

A. Push Down on Cap

     to Open Hole

B. Insert Bare Wire

     into Open Hole

C. Release Cap

     to Secure Wire

10. Slide the speaker onto the mount’s wall section as shown in  

      the illustration. Pull any slack speaker wire back through 

      the mount's wall section.

11. Fit the metal stop plate into the recess on the bottom of the   

      mount with the pad facing the mount, and fasten it to the  

      mount using two of the supplied screws. This will prevent 

      the speaker from detaching from the bracket and will hold    

      the speaker’s position as you rotate it on the mount.

Slide Speaker

onto Wall-Mount

Stop Plate
Supplied Screws

9. Slide the speaker portion of wall-mount onto the speaker as shown in 

    the illustration. Fit the grooves on the mount onto the rails in the speaker,  

    and apply even pressure on both sides of the mount so it slides straight  

    onto the speaker.

   • Push the mount all the way onto the speaker until it snaps into place.

   • Pull any slack speaker wire back through the mount as you slide the   

      mount onto the speaker.

Fit Bracket Grooves

onto Speaker Rails

Push Down Evenly on Both Sides of Bracket

NOTE: If you’re running the speaker wire through the wall you can bring 

it out directly behind the bracket location and insert it through the 

bottom opening in the wall portion of the wall-mount, as shown in the 

illustration. This will keep the wire completely hidden from view once 

the installation is complete.

Insert Wire into

Bottom Opening

Bring Wire Out

through Here

Harman Kardon

HKTS 20+30+60 Service Manual

Page 17 of 49