HKTS 35BQ
4
Subwoofer Rear-Panel Controls and Connections (cont.),
Color-Coding System, and Speaker Placement
Transmitter Unit
1
2
WIRELESS
CODE
DC 5V
INPUT
R
3 4
L
Wireless
Code
Switch
Input
Connectors
Power
Connector
Power connector:
Plug the transmitter power supply into this connector and into a
working AC outlet.
Wireless Code switch:
This switch selects between four different channels for the
wireless signal.
IMPORTANT:
Be sure to set the transmitter unit’s Wireless Code switch to the same
channel that you set the subwoofer’s Wireless Code switch. See
Wireless Code Settings,
on page 10, for more information.
Input connectors:
Connect the supplied LFE cable from your receiver’s or processor’s
subwoofer output to either of the transmitter unit’s Input connectors.
Color-Coding System
The HKTS 35 system uses the channel color-coding system established by the CEA to
make setting up your home theater speaker system as easy as possible. The system
includes speaker wires and an LFE cable with color bands on each end.
Speaker Position
Wire Color Bands
Front Left
White
Front Right
Red
Center
Green
Surround Left
Blue
Surround Right
Gray
Subwoofer
Purple
Speaker Placement
Front speakers
Front Left
Speaker
Front Right
Speaker
Place the front speakers the same distance from each other as they are from the listener’s
position. Place them at about the same height from the floor as the listener’s ears will be.
Angling them towards the listener can improve the stereo imaging.
Center Speaker
Center Speaker
Front Left
Speaker
Front Right
Speaker
0 – 2 ft
(0 – 61cm)
Place the center speaker directly above or below the center of your TV screen. Its center
should be no more than two feet (61cm) above or below the centers of the front left and
front right speakers. If your TV set is deep enough, it may be convenient to set the center
speaker on top of the television set.
