8
SB 10
Connections
+
–
+
–
+
–
FRONT
LEFT
+
–
+
–
SURROUND
RIGHT
CENTER
L
C
R
– + – + – +
Speaker Wires
(included)
SB 10 Soundbar
Receiver or Amplifier
Connections
CAUTION:
Before making speaker connections, be sure that your receiver or amplifier
is turned off. If possible, make sure that its AC cord is unplugged from the AC power
outlet.
Soundbar Connections
The SB 10 soundbar contains left-, center- and right-channel speakers that connect
to your audio/video receiver or amplifier’s front left, center and front right speaker
outputs.
To connect each wire to the soundbar:
Press down on the terminal cap to open the connection hole on the soundbar’s
1.
speaker terminal.
Insert the wire’s bare end all the way into the hole. Insert the conductor with the
2.
colored band into the speaker’s red (+) terminal, and insert the other conductor
into the speaker’s black (–) terminal, as shown in the illustration.
Release the cap to secure the wire.
3.
IMPORTANT:
Make sure the (+) and (–) bare wires do not touch each other or the other
terminal. Touching wires can cause a short circuit that can damage your receiver or
amplifier.
Subwoofer Connections
1a. If your receiver/processor has a dedicated subwoofer output with low-pass
filtering (also called bass management), use the included LFE cable to connect
the subwoofer’s Line-Level LFE In jack to the dedicated subwoofer output (or
LFE output) of your receiver or preamp/processor.
Configure your receiver or preamp/processor’s setup menu for Subwoofer ON, and set
the front left, front right, center and surround speakers to Small.
–
+
1. Push Down on
Cap to Open Hole
2. Insert Wire Into
Open Hole
3. Release Cap to
Secure Wire
SUBWOOFER
LFE OUT
+
–
+
–
+
–
FRONT
LEFT
RIGHT
+
–
+
–
SURROUND
LEFT
RIGHT
CENTER
LFE Cable
(included)
Receiver or Amplifier
Subwoofer
harman/kardon
SB 10 / 230V Service Manual
Page 5 of 16