11
SB 30
ENGL
IS
H
Subwoofer Phase Switch
When the subwoofer is properly in phase with the soundbar speakers, the sound will be
clearer and have more impact. In-phase performance will make percussive sounds like
drums, piano and plucked strings sound more lifelike. Although there is no absolutely
correct setting for the subwoofer’s Phase switch, in most cases it should be left in the
“Normal” position. The best way to set the Phase switch is to listen to music that you
are familiar with and adjust the switch so that drums and other percussive sounds have
maximum impact.
This area is designed to become
quite warm during normal operation
RISK OF ELECTRIC SHOCK
DO NOT OPEN
RISK OF ELECTRIC SHOCK
DO NOT OPEN
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Phase
Switch
Adjusting the System’s Volume
Press the Volume Up and Down buttons on the soundbar or the remote control to raise
and lower the system’s volume one step at a time. Hold down the buttons to raise or lower
the volume continuously. To mute the system, press the remote control’s Mute button.
Volume Down/Up
Buttons
Mute Button
Volume Down/Up
Buttons
For the best sound, we recommend turning your TV’s built-in speakers off. Consult your
TV’s owner’s manual to find out how to do it. If there is no way to turn your TV’s speakers
off, you can adjust your TV’s volume so that the SB 30 system will always supply most
of the sound:
1. Using the volume buttons on your TV, turn its volume all the way down.
2. Then use the soundbar’s Volume Up/Down buttons to set the sound to a comfortable
listening level.
Selecting an Input Source
Press the Source button on the soundbar or the remote control to switch among the three
sources: optical digital, coaxial digital and analog.
Source
Button
Source
Button
The soundbar’s Status LEDs will glow white to indicate the active source.
Optical Digital
Analog
Coaxial Digital
Surround Modes
Your soundbar incorporates extremely sophisticated digital signal processing that, along
with 13 individual transducers powered by 11 amplifier channels, creates an astonishingly
realistic surround-sound presentation in any size room, for listeners at any position in the
room, without needing any extra speakers or wires.
Press the Surround Mode button on the soundbar or the remote control to switch among
the three surround modes: Stereo, Virtual and HARMAN Wave.
Surround Mode
Button
Surround Mode
Button
The soundbar’s Status LEDs glow blue to indicate the active surround mode:
Stereo
HARMAN Wave
Virtual
Using Your Soundbar Speaker System
