6
4 GLASS
RETAINER
CLIPS
4 GLASS
RETAINER
BOLTS
GLASS
GLASS GASKET
DOOR
HINGE PINS
SET SCREW
BRASS HANDLE
HANDLE BOLT
WOOD HANDLE
PAW BOLT
Assembling the door
Referring to Figure 3, note how the various com-
ponents of the door system fit together. Lay the load
door face down on a soft surface.
Clean the glass and gold door using a nonabrasive
cleaner. Install the glass gasket around the outer edge of
the front face of the door glass carefully to insure proper
sealing. Set the glass pane gently onto the door. Install
the hold-down clips and tighten with bolts as shown.
Install door on stove with hinge pins.
Install door handle as shown on the diagram.
NOTE: With the flat surface of the paw bolt to the in-
side of the door.
Turn the paw bolt "in" for approximately 17 turns.
Turn the brass elbow onto the paw bolt approxi-
mately 5 turns.
Align the set screw with the flat spot on the paw
and tighten.
After attaching the door handle, close and latch
the door by turning the handle to the six o'clock posi-
tion. Does the door rope compress? If not, loosen the
set screw, and turn the paw bolt one more turn into the
door. Repeat as required to achieve a tight door fit.
NOTE: Remember to thoroughly clean the glass
and the gold door frame before lighting the stove for the
first time.
Fig. 4
Fig.3
Summary of Contents for 44 Magnum
Page 21: ...21 Wiring Diagram ...