27
PC 45 Corn/Pellet Stove
Optional Trim
There are three different finishes to choose from,
gold, brushed stainless, and bright nickel. Each trim
kit includes a door frame, a drill bit for the load door
holes, an ash door tile trim, and an ash fender trim. The
ash door tile frame can be installed with or without the
decorative tile.
To install the door frame, lay the frame face down
on a soft surface. Fasten door frame by inserting the 4
threaded posts on the frame through the door. The posts
should line up with the 4 holes located at the corners of
the door. Once the posts are through the door, fasten
frame with 4 nuts and tighten until the frame is snug.
To install ash lip trim, simply slide the trim over the
ash lip and into the groove on the trim.
The ash door frame includes a bent spring clip. Insert
the spring clip into one end of the frame. Start the frame
into the recessed area of the ash door with the clip end
first. push tension on the spring clip while inserting the
other end of the frame into the recess.
Cleaning Plated Trim
Gold or nickel plated hardware should never be buffed
or polished. Abrasive cleansers and metal polishes will
remove the plating and therefore should never be used.
If the plating needs to be cleaned, wait until the stove
is completely cool, then use a sponge, soap and water
to gently remove dirt and stains. Before relighting the
stove, remove all soap residue and wipe dry.
Options
Fig. 41
decorative Tile
Decorative tile is available in four choices of slate or
a brushed stainless deer cutout (shown above). The tile
installs behind the trim on the ash door.
direct vent wall Passthrough
The direct vent wall passthrough allows you to bring
outside air in for combustion, and safely pass your pellet
venting through the wall while only needing to make one
hole. The pass through is adjustable for different wall
thickness from 4½" to 10⅛" thick. Item # 1-00-677077
is compatible with 3" venting only.
Inner half
Outer half
Optional hopper Screen (Corn Strainer)
The hopper screen/corn strainer was designed to
sift the corn as it is loaded into the hopper. This sifting
will catch unwanted materials from being burned. The
strainer also includes a removable funnel to aid in fuel
handling.
burnpot grates
The PC-45 includes two burn grates. You'll notice
that they each have different sized air holes in them.
Use the grate that fits your fuel the best. In most cases,
the smaller holes will be best with corn and the large
holes will be best for pellets. Feel free to experiment
with both grates.
