Installation
Only For Qualified Installers
Connect the gas pipe to the stove unit. If the pipe
adapter was removed from the stove, replace all
components back onto the stove in the reverse
order from which they were removed.
9
Place log set in firebox. Center the logs right to left
and push back against the log stop.
The power cord comes out the right side of the unit
from the factory. The power cord may be changed
to the left side before installing the face. Start by
bringing the plug end of the cord back through the
side of the firebox, and lifting the strain relieved
cord section up from body notches. Keeping the
cord along the front of the stove bottom run the
plug end under the label holding brackets and
out the same area on the other side of the stove
body. Press the strain relieved cord section into
the notches on the left side of the stove body and
secure the cord to the front bottom section of the
stove using wire ties.
11
12
Back out the 4 face clamping bolts far enough
to install the face. Slide the face onto the firebox
assembly until the slots are just fully under the
heads of the bolts and are all even, then tighten
the 4 bolts as shown above. Check to see if the
back of the stove face meets with the fireplace
opening as neatly as possible, some adjustment
may be necessary. If the face is slid too far back
under the bolts the glass door will not be able to
be removed without taking the face off first. Some
applications may be required to be installed that
way.
10
Place rock wool on burner as shown above. The
wool should be placed loosely and lightly. This
wool forms the glowing ember bed and will look
different depending on placement. Reinstall the
glass door assembly and close the latches.
Do not stike glass or close door with excessive
force. Breakage of glass and/or damage to door
may result.
22
