Maintenance
Air In
Air Out
The flow of convection air must not be obstructed.
Cleaning the Burners
To clean the burners, the face, glass front, and log
set must be removed. Remove the burner assembly as
described on page 15.
With the burner removed, inspect all of the holes
to make sure they are unobstructed. Use a small drill or
wire to clean any obstructed holes. Remove any rust or
other buildup that may have accumulated.
Replace burner in reverse order.
Replacing The Blower
To replace the blower the stove must be removed from
the fireplace.
1. Shut off power and gas to stove
2. Remove face assembly
3. Remove glass door
4. Remove log, Rear brick panel and firebox rear cover
plate.
5. Loosen nut on “J” bolt under the cover and remove
“J” bolt
6. Disconnect power cord and gas line
7. Protect hearth
8. Remove stove from fireplace being careful not to
damage flex pipes while removing adapter from the top
of the stove.
9. Remove rear cover from stove body
10. Disconnect wires from blower motor
11. Remove screws mounting blower to blower mount
12. Replace blower.
13. Assemble in reverse order.
Air Flow
To prevent damage to the heater, it is essential that
air flows freely into the bottom grill and out of the top
grill. Do not place objects in front of the grills.
The appliance should be inspected before
use and at least annually by a qualified
service person. More frequent cleaning
may be required due to excessive lint
from carpeting, bedding material, etc. It
is imperative that control compartments,
burners and circulating air passageways of
the appliance be kept clean.
“If the vent/air intake system is disassembled
for any reason, reinstall per the instructions
provided for the initial installation.”
CAUTION: Label all wires prior to disconnection
when servicing controls. Wiring errors can
cause improper and dangerous operation.
“Verify proper operation after servicing.”
“Attention: Au moment de l’entretien des
commandes, eriquetez tous les fils avant
le debranchement. Des erreurs de c>blage
peuvent entraTun fonctionnement inadequar
et dangereux.”
Only use Authorized Harman Service
or Repair parts when working on your
Shadowlight XL gas fireplace insert.
26
