Harman® • Allure50 Owner’s Manual_R24 • 2016 -___ • 03/21
26
3-90-888000c
Step 1 - Installing Side Panels:
Locate the cut-outs in the
top of the panel that marry to the hooks located underneath
the cast top. Once in place simply place the bottom of the
panel flush against unit. Figure 1.
Step 2:
Tighten the (4) 10-24 x 1/2” Thread cutting screw
using a 5/16” nut driver, (2) Thread cutting screws per panel.
Figure 2.
(Note: The door does not need to be removed
to access screws.)
Helpful Hint;
When tightening the right panel front screw,
open the door slowly until it contacts the side panel. This
will push the side panel fully into the slot for tightening from
the front.
Figure 1
Step 4 - Installing columns with no glass:
Door must
be slightly open. Insert right column from the side. While
holding column to the door swing door open and install (3)
10-24 x 3/8” Button Head Screws at the top, center and
bottom of the door. Figure 4. Repeat step for other side.
Note: Use 1/8” Allen Wrench supplied with stove.
Top of door
Figure 4
Figure 2
Front side
Back side
Step 3 - Installing glass:
If glass is not being installed
move onto step 4.
Install right side column, do not tighten
screws. Prior to installing glass make sure the end marked
“Top” is up. Slide glass behind right hand column and push
glass flush with door and center glass. Figure 3. Install the
left column and tighten (3) 10-24 x 3/8” Button Head Screws
at the top, center and bottom of the door, tighten right side
column. Figure 4.
Note: Use 1/8” Allen Wrench supplied
with stove.
Figure 3
Slide glass
behind column
F. Glass Installation and Cleaning
