troubleshooting
DMS800 MANUAL
112
ERROR
POSSIBLE CAUSE
CORRECTION
Brief dropouts at
some points of
the action area.
Receiver or antennas incorrectly positioned
Reposition receiver or remote anten‑
nas.
If dropouts remain, mark and avoid
critical points.
Transmitter is too far away from the receiv‑
er.
Move the transmitter to the receiver
RF LOW
The field strength of the reception signal
is so low that the receiver is automatically
muted to avoid interference noise.
Reposition receiver or use remote
antennas.
AF CLIP
The audio signal overrides the A/D convert‑
er of the transmitter.
Reduce audio input level.
ANT ERROR
The same antenna has already been active
for more than two minutes.
Check if the antenna cable is faulty or
incorrectly connected.
LOW BATT
The capacity of the transmitter battery will
soon be depleted.
Insert new batteries.
SYSTEM ERROR
Internal error.
Switch off receiver and switch back on
after approx. 10 seconds. If the error
occurs again, contact your AKG service
centre.
RF ERROR,
PLL ERROR
Receiver cannot be synchronized to the set
frequency.
Tap the SELECT wheel to confirm
errors and set another frequency. If the
error occurs again, contact your AKG
service centre.
UPDATE
FIRMWARE
System is ready for software updates.
Switch off receiver and switch back on
after approx. 10 seconds. If the error
occurs again, contact your AKG service
centre.
INTERFERE
ERROR
Errors due to other wireless systems, TV,
radio, wireless devices or harmful electrical
equipment or installations.
Change frequency or switch off device
creating the interference.
ENCRYPTION!
Encryption not set correctly.
Synchronise transmitter.
Errors due to other DMS800 transmitters.
Change carrier frequency (resynchro‑
nise)