REACH
REACH (Regulation No 1907/2006) addresses the production and use of chemical substances and their
potential impacts on human health and the environment. Article 33 (1) of REACH Regulation requires
suppliers to inform the recipients if an article contains more than 0.1% (per weight per article) of any
substance(s) on the Substances of Very High Concern (SVHC) Candidate List (‘REACH candidate list’).
This product contains the substance ‘’lead’’ (CAS-No. 7439-92-1) in a concentration of more than
0.1% per weight.
At the time of release of this product, except for the lead substance, no other substances of REACH
candidate list are contained in a concentration of more than 0.1% per weight in this product.
Note:
on June 27, 2018, lead was added to the REACH candidate list. The inclusion of lead in the REACH
candidate list does not mean that lead-containing materials pose an immediate risk or results in a
restriction of permissibility of its use.
CAUTION FCC AND IC STATEMENT FOR USERS (USA AND CANADA ONLY)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
CAN ICES-3 (B)/NMB-3(B)
FCC SDOC SUPPLIER’S DECLARATION OF CONFORMITY
HARMAN International hereby declares that this equipment is in compliance with the FCC part 15 Subpart
B.
The declaration of conformity may be consulted in the support section of our web site, accessible from www.
AMX.com.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures;
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Caution:
Changes or modifications not expressly approved by Harman could void the user’s authority to
operate the equipment
.
