Installation
7
Vision
2
Instruction Manual
Installation
This section provides instructions on how to install the different Vision
2
accessories.
Installing Master Server Accessories
Optional accessories can be installed in the Master server for redundant power or for connection to an Archive server.
Installing a Secondary Power Supply
The V2-POWER-1100 (
FG3106-PS
) is a secondary power supply that can be used to add redundant power to FG3106-XX Vision
2
Master Servers. Master servers ship with a single 1100W power supply. One additional V2-POWER-1100 can be added to the server
to provide power supply redundancy.
NOTE:
The V2-POWER-1100 power supply is only compatible with the FG3106-XX Vision
2
Master servers
Follow these steps to install a secondary power supply.
1.
Remove the metal cover from the power supply expansion slot (see FIG. 8).
2.
Slide the secondary power supply into the slot until the orange tab beside the power connector clicks into place.
Installing Expansion Storage
The following steps describe how to add an additional 24TB of Disk storage to an existing archive server.
1.
Connect an SAS cable to the IN port on the rear of the V2-STORAGE-2400 Expansion Storage device (FIG. 10).
2.
Connect the other end of the cable to the first SAS port on the rear of the Master server.
FIG. 7
V2-POWER-1100 Power Supply
FIG. 8
Master Server Rear Panel
FIG. 9
Vision
2
Archive/Video on Demand server with V2-PVA (rear-view)
FIG. 10
V2-STORAGE-2400 Expansion Storage (rear-view)
Remove metal cover
from expansion slot.
