Install the Center Log
the center log goes all the way to the back and should
be centered. When properly positioned, there should be an
even gap along the front of the center burner in the cavity
in the log. a small portion of the log support frame will be
revealed.
the center log has a round viewing port in the left end
through which the pilot can be observed.
Install the Branch
orient the branch with the forked end toward the left rear
of the stove and slip it over the two locator pins, one on top
of the back log and the other on the top of the center log.
Secure the Glass Front
note: the glass front is heavy. Lift it carefully to pre-
vent damage. center the glass on the opening and suspend
it in place by placing the the tab hooks over the top edge
of the opening. Loosen the wing nuts that hold the spring-
loaded levers in place. Press the glass slightly against the
stove to confirm that it seats properly, then press it firmly
against the front while pulling the levers forward to engage
them. tighten the wing nuts.
the complete log set with all logs in the correct position.
ASSEMBLY
Any safety screen or guard removed for servicing an
appliance must be replaced prior to operating the ap-
pliance.