Harman DigiTech JamMan Vocal XT, Owner'S Manual

7

Undoing/Redoing Overdubs

When recording overdubs, you can choose to undo the last overdub recorded if you wish 

to re-record it� If you change your mind or accidentally undo an overdub, you can then use 

the redo function to retrieve it� 

To undo/redo an overdub:

1�  Record an overdub as described in the previous section, "Recording Overdubs"�

2�  Ensure the loop is playing (the 

PLAY LED

 should be on)� If the loop is not playing, press 

the 

FOOTSWITCH

 to initiate loop playback� Once the loop is playing, press and hold 

the 

FOOTSWITCH

 for ~2 seconds� The 

DUB LED

 will quickly flash yellow, indicating the 

overdub has been undone� 

3�  If you wish to restore the overdub, press and hold the 

FOOTSWITCH

 again for ~2 

seconds� The 

DUB LED

 will quickly flash yellow, indicating the redo function has been 

performed and you should now hear the overdub again�

NOTE: Each time an overdub is added, the last overdub is merged with the original loop 

and can no longer be undone using the undo function� If the combined loop and overdub 

length exceed 10 minutes (e�g�, a 6 minute loop and 6 minute overdub, etc�), the two 

will automatically be merged and the overdub cannot be undone� Overdubs added to a 

recorded loop of 5 minutes or less will not be automatically merged�

Clearing a Phrase

Clearing a phrase allows you to re-record it or record a new phrase� The JamMan Vocal XT 

has a unique feature, referred to as “Silent Clear

™

”, which clears a phrase without requiring 

you to play it first� Note that you cannot undo the process of clearing a phrase, so make 

sure you want to proceed before performing this function�

To clear a recorded phrase:

1�  Stop loop playback if it is not already (all LEDs should be off)� If loop playback is active 

(the 

PLAY LED

 is on), press the 

FOOTSWITCH

 2 times to stop loop playback�  

2�  Press and hold the 

FOOTSWITCH

 for ~3 seconds� The 

REC LED

 will quickly flash red, 

indicating the phrase has been cleared�

NOTE: When using a slave/master looper setup, if the master loop is ~3 seconds or less 

and if pressing and holding the 

FOOTSWITCH

 from a stopped state does not initiate 

clear on the slave device, you may need to initiate play then stop (3 

FOOTSWITCH

presses) and hold the footswitch on the 3rd press to clear its loop�