8
Using JamSync™
Connection & Record Sequence
JamSync allows you to synchronize multiple JamSync compatible devices using optional 1/8”
mini stereo (TRS) cables (see below cable diagram)� This allows a JamSync master to control
the loop playback and stop functions for all connected JamSync slaves, providing multi-track
looping capabilities� You can cascade multiple JamMan Vocal XTs for single-player/multi-
track looping or connect to other JamSync compatible devices to collaborate with other
musicians, each recording and cueing their own loops for expressive multi-player/multi-track
looping�
1/8” Mini Stereo (TRS) Cable Diagram
1/8” Stereo Cable (TRS)
Sleeve (Ground)
Tip
Ring
Tip
Ring
Ring
Sleeve
(Ground)
Tip
Sleeve
(Ground)
To use JamSync, connect the master
device’s
JAMSYNC OUT
jack to the
JAMSYNC IN
jack of the first slave
device� The
REC
and
PLAY
LEDs on
the slaved device will briefly flash,
indicating the unit is in slave mode�
Daisy chain any remaining slaves in
the same manner�
When cascading multiple JamMan
Vocal XTs in series and using
JamSync, the last Vocal XT device in
the chain will be the master� You will
want to record to this master device
first, then the second to last device,
etc�, working your way backwards
through the signal chain� Performing
these actions will ensure you record
only what you intend to during each
pass�
Record First
MASTER
Record Second
SLAVE
IN
OUT
MIC
OUT
TO NEXT J
AMS
YNC SLA
VE
TO MIXER
JAMSYNC
Indicates
Slave
Status
