www.jbl.com
E
ngli
sh
13
13
6. SETUP
6.1 Connect the detachable rear speakers and
subwoofer
POWER
1
2
POWER
LOAD
READY
HELLO
1. Connect the soundbar to power by using the supplied power
cord.
→
The screen on the soundbar shows “
” and then,
“
”.
2. Do the following to start the connection:
•
Connect the subwoofer to power by using the supplied
power cords;
•
On the soundbar, press to switch on;
•
Dock the detachable speakers onto the soundbar, or
press on the detachable speakers to fast re-connect to
the soundbar.
→
The soundbar connects the subwoofer automatically.
Connected:
turns solid white on the subwoofer.
→
The soundbar connects the detachable speakers
automatically.
Connected:
The status indicator turns solid white ( ) on
the detachable speakers.
6.2 Charge the detachable speakers
Wi-Fi and Bluetooth connection will be off and the soundbar will
enter into power saving mode when the detachable surround
speakers are out of battery.
The first time you use the two detachable speakers, charge them
for more than 3 hours to ensure sufficient battery power.
→
When the battery power runs low, the status indicator
flashes red on the detachable surround speakers and “
” is displayed on the soundbar.
→
When the battery power runs out, “
” or
“
” is displayed on the soundbar.
CHARGE SPKR. BATT LOW
6.2.1 Charge by docking the detachable speakers
With the detachable speakers docked, the soundbar will enter the
charging mode after switching to standby mode.
→
: The detachable speakers are fully charged
( turns off). The soundbar returns to standby mode.
→
The charging mode exits when the soundbar is switched
on (after auto wake-up or by your pressing on the
soundbar or remote control). See “Power-on/Auto-
standby/Auto wake-up/Power-saving mode” in the
“PLAY” chapter
.
→
It takes about 3 hours for the empty battery to be fully
charged.
STDBY
3H
100%
