8
DO NOT BURN WET COAL
IMPORTANT
Be sure the grate holder is centered
and back as far as possible.
hopper
Install hopper support on top rear of stoker.
Note that the bolt holes in the hopper support are slotted
for adjustment. Insert the funnel end of hopper into the
hopper slot on the feeder as shown. Push the top of the
hopper under the hopper support, causing the slot on the
bottom side of the support to hook onto the hopper. The
hopper support will spring up slightly for the hopper to
go under. If you have difficulty getting the hopper under,
adjustment may be necessary. Use slotted holes shown
at left. Now the feed motor cover can be installed.
grate
The grate is composed of four pieces: the grate holder, (2)
grate inserts, and grate angle. The grate angle is bolted
to the grate holder with (2) 3/8 X 1 1/4 bolts. Before
installing the grate holder, the 3/8" round gasket must
be checked in the groove on the bottom side of the grate
holder, as shown in fig. 7. Check to be sure the gasket
has not been damaged.
The grate holder must be installed through the top door
opening after the feeder has been installed.
Locate the flange at the rear of the grate holder into the
slot on the feeder as shown below. Bolt the front end down
with the 1/4 x 20 Allen bolt and nut provided. The rear end
will be locked in place by the flange. Before tightening the
bolt be sure the grate holder is back as far as possible
and centered side to side on the feeder opening.
Install grate inserts as shown at left. Divide the spaces
between the inserts equally and be sure they are not tight.
The spaces are needed for expansion.
Summary of Contents for Magnum Stoker
Page 5: ...5 DO NOT BURN WET COAL PACKING LIST...
Page 21: ...21 DO NOT BURN WET COAL 37 5 25 40 5 31 5 36 5 SPECIFICATIONS...
Page 31: ...NOTES...
Page 32: ......
