24
Martin Professional™ VC-Feeder user manual
Service
Warning! There are no user-serviceable parts inside the VC-Feeder.
Refer any service operation not described in this guide to Martin
Professional or its authorized service agents.
Installation, on-site service and maintenance can be provided worldwide
by the Martin Professional Global Service organization and its approved
agents, giving owners access to Martin’s expertise and product knowledge
in a partnership that will ensure the highest level of performance
throughout the product’s lifetime. Please contact your Martin supplier for
details.
The only service operation the user can carry out on the VC-Feeder is
occasional cleaning and uploading software, if this should ever be
necessary.
Cleaning
Warning! Do not immerse the VC-Feeder or expose it to high-
pressure water jets.
Do not use abrasive, caustic or solvent-based products for cleaning, as
they can encourage corrosion and cause surface damage.
To clean a VC-Feeder:
1. Disconnect the installation from power.
2. Clean the outside of the device with a soft cloth dampened in a warm
water/detergent solution.
Software installation
It may be necessary to upload new software (i.e. firmware) to a VC-Feeder
if you believe that the product has a software-related fault or if you want to
update to a newer version. Software updates are available from the Martin
website (http://www.martin.com) and can be installed from the P3 system
controller.
Summary of Contents for Martin VC-Feeder
Page 1: ...VC Feeder User Manual...
Page 30: ......
Page 31: ......
Page 32: ...www martin com Olof Palmes All 18 8200 Aarhus N Denmark Tel 45 8740 0000 Fax 45 8740 0010...
