36
Vibrato
Vibrato is obtained by smoothly varying the pitch of the signal just sharp and flat of the original at a deter-
mined rate.
Vibrato
Stereo (Wet only)
Rotary
Mono (Wet only)
Tremolo/Pan
Stereo (Wet only)
Knob 1: Speed
Controls the modulation rate of Vibrato.
Knob 2: Depth
Controls the maximum amount of pitch shift. Lower settings result in a mere “warble,” while
higher settings produce a more exaggerated “wow” sound.
Knob 3: Phase
This control sets left and right channel waveforms out of phase, resulting in a left-to-right
panning motion. This effect shifts the frequency spectrum of the input signal. Altering the pitch of a sound
produces a wide range effects - from subtle detunes to full interval shifts up or down a two octave range.
FACTORY RESET
Use this function if you want to erase all program data and restore the effects processor to its factory state. To
perform a
Factory Reset
press and hold the STORE button while powering up the console. Once the effects
processor has initialized (after three seconds), then release the STORE button and the effects processor will
be restored to its factory state.
Summary of Contents for MFXi
