Harman® • P43 Installation Manual_R23 • 2008 -___ • 04/14
4
3-90-04301i
A. Appliance Certification
D. BTU & Efficiency Specifications
B. Glass Specifications
This appliance is equipped with 5mm mirrored ceramic
glass. Replace glass only with 5mm ceramic glass. Please
contact your dealer for replacement glass.
C. Mobile Home Approved
This appliance is approved for mobile home installations
when not installed in a sleeping room and when an outside
combustion air inlet is provided.
The structural integrity of the mobile home floor, ceiling, and
walls must be maintained. The appliance must be properly
grounded to the frame of the mobile home and use only listed
pellet vent, Class “PL” connector pipe.
A Harman® Outside Air Kit must be installed in a mobile
home installation.
NOTE:
This installation must conform with local codes.
In the absence of local codes you must comply with
the
ASTM E1509-2004, ULC S628-93, ULC/ORD-C-
1482-M1990, (UM) 84-HUD
*BTU output will vary, depending on the brand of fuel you use in your
appliance. Consult your Harman® dealer for best results.
MODEL:
P43 Pellet Stove
LABORATORY:
OMNI Test Laboratories, Inc
REPORT NO.
135-S-23b-6.2
TYPE:
Pellet Fueled/Supplementary For
Residential Use
STANDARD(s):
ASTM E1509-04, ULC/ORD-C1482-M1990,
ULC-S627-00
Particulate
Emissions Rating:
N/A
*BTU Output:
8,000 - 43,000 / hr
Heating Capacity:
up to 2,400 sq. ft. depending on
climate zone
Hopper Capacity:
50 lbs
Fuel:
Wood Pellets or Shelled Corn
Shipping weight:
250 lbs
NOTE:
Hearth & Home Technologies, manufacturer of
this appliance, reserves the right to alter its products, their
specifications and/or price without notice.
WARNING! Risk of Fire!
Hearth & Home Technologies disclaims
any responsibility for, and the warranty and agency listing will be
voided by the below actions.
DO NOT:
• Install or operate damaged appliance
• Modify appliance
• Install other than as instructed by Hearth & Home
Technologies
• Operate the appliance without fully assembling all
components
• Overfire
• Install any component not approved by Hearth &
Home Technologies
• Install parts or components not Listed or approved.
• Disable safety switches
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualified
installer, service agency or your dealer.
Harman® is a registered trademark of Hearth & Home
Technologies.
The P43 Freestanding Pellet Stove by Harman® is exempt
from Environmental Protection Agency certification under
40 CFR 60.531 by definition [Wood Heater (A) “Air to Fuel
Ratio].
1
Product Specific and Important Safety Information
wARNING
THE STRUCTURAL INTEGRITY OF THE
MANUFACTURED HOME FLOOR, wALL, AND
CEILING/ROOF MUST BE MAINTAINED.
DO NOT INSTALL IN SLEEPING ROOM.
E. Non-Combustible Materials Specification
Material which will not ignite and burn. Such materials are
those consisting entirely of steel, iron, brick, tile, concrete,
slate, glass or plasters, or any combination thereof.
Materials that are reported as passing
ASTM E 136,
Standard Test Method for Behavior of Materials in
a Vertical Tube Furnace at 750° C
and
UL763
shall be
considered non-combustible materials.
F. Combustible Materials Specification
Materials made of or surfaced with wood, compressed
paper, plant fibers, plastics, or other material that can ignite
and burn, whether flame proofed or not, or plastered or un-
plastered shall be considered combustible materials.
G. Electrical Codes
115 VAC, 60 Hz, Start 4.2 Amps, Run 2.8 Amps
NOTE: Some generator or battery back-up systems may
not be compatible with the micro-processor electronics
on this appliance. Please consult the power supply
manufacturer for compatible systems.
