27
P68 Pellet Stove
The glass in your Harman stove is a special
5mm ceramic glass.
• Do not abuse the glass by striking or
slamming the door.
• Never burn the appliance if the door glass is
cracked or broken.
• Replace only with Harman supplied glass.
Do NOT Use Substitutes.
Soot and/or fly-ash may accumulate on the
viewing glass, and will ocassionally need to be
cleaned. Clean the glass with a soft cloth and
mild glass cleaner. Do not clean the glass when
hot, and avoid the use of abrasive cleaners.
Glass replacement
Carefully remove all remaining glass and gasket
materials prior to replacing the glass.
Lay the door face down on a flat surface.
Remove the glass retainers and screws. Apply
the gasket material to the face of the new glass.
Lay the glass into the door, making sure that the glass is contained within the channels and raised areas of
the door itself. Lay the glass retainers into position and install the screws. Tighten each screw evenly to avoid
making any stress points.
Retainers and screws
Glass
Adhesive gasket
Door Frame
Maintenance
Pellet fines may accumulate in the feeder body over
a period of time; therefore, a yearly inspection and
cleaning of this must be performed.
To clean out fines:
1. Remove right rear cover panel.
2. Remove wing nuts and feeder cover on the right
side of the feeder.
3. Use a vacuum cleaner to remove all fines.
4. Reinstall feed cover, wing nuts, and right rear
cover panel.
Pellet Fines may build
up in this area
5/16" Hex Head
Screws (2 on
each side)
5/16" Hex Head
Screws (2 on
each side)
