26
1.
Turn Mode Selector to “OFF”.
This resets the control in addition to turning it off.
Starting A Fire Automatically
Operation
2.
Clean Burnpot
with scraper, if necessary.
This is usually a weekly maintenance procedure.
Cleaning the burn pot with the scraper with a small
amount of new fuel in the bottom is not a problem. First,
scrape the ashes on the front of the burn pot into the ash
pan. Then scrape the hole grid surface downward into
the burn pot. When the stove is ignited these scrapings
will be pushed out by the feeder.
The illustration at left shows the hopper swing plate
open for easy access to the burn pot. The burn pot can
also be reached through the firebox door.
NOTE: To minimize the amount of stress placed on
the hopper swing plate hinges, opening of the hopper
swing plate should be done with the least amount of
fuel in the hopper as possible.
3.
Fill Hopper
with pellets.
When filling the hopper check for excessive fines
in the bottom of the hopper. Fines are small pieces of
broken pellets (sawdust). Fines do not flow easily and
often build up on the hopper funnel bottom angles.
These fines can be pushed into the feeder opening and
then fill the hopper with pellets. As the system works,
they will be burned.
Ash Pan
Ash Pan Handle
Scrape burnpot to remove any carbon
build-up that may have occurred
Scraping can be done while in operation
Summary of Contents for PB 105
Page 2: ......
Page 45: ...45 Service Record Notes...
Page 46: ...46 Service Record Notes...
