© 2015Harmar Mobility, LLC • All Rights Reserved
| www.harmar.com
18
Pinnacle 101 Stair Lift
FOLDING RAIL INSTALLATION
7.
Fasten down the near corner of the lower bracket
using a drill that has extensions at least 10"long and
a 3/8” socket.
[Figure 22-1 & 22-2]
8.
Measure from the side of the rail at the upper
bracket of the folding rail.
Set this at 3" or more. Screw down one corner of the
bracket.
9.
Join to upper rail, following regular procedures
(this procedure is detailed on page 5). This
procedure includes plugging the battery charging
wire harness for the folding rail into the charging
harness from the upper rail. The power supply itself
can be plugged into either the top rail (for the top
of the stairs), or to the charge plug from the folding
rail, which comes out just higher than the folding
mechanism for the bottom of the stairway.
10.
Fasten down the other screws of both rail
brackets using the power drill and long extension
with the 3/8” socket.
[Figure 22-3]
Figure 22-3
Figure 22-2
Figure 22-1
Figure 22-4
11.
Adjust the height of the two feet using a 9/16"
open end wrench. Set them so that both rest on
the floor with the rail fully straight. The foot farther
from the wall should be set a little taller than the
inside one to get it to seat flat on the floor, since
the Pinnacle rail brackets intentionally lean the rail
toward the wall just a little.
[Figure 22-4]
