ES
AE
R
G
ES
AE
R
G
ES
AE
R
G
ES
AE
R
G
ES
AE
R
G
ES
AE
R
G
12
Section 2 : inStaller
Safety & Maintenance
NoteS For
aL015,
aL100
aND
aL160
moDeLS
WarNING!
On some scooters, it
may be necessary to
temporarily move the
steering tiller forward to
clear the hold-down arm
as it lowers into the lock-
down position.
WarNING!
Some scooters have
pneumatic (air inflated)
tires. If your scooter has
this type tire, be sure the
tires are properly inflated.
Improper inflation will
change the deck height of
the scooter and therefore
change the amount of
clamping force the hold-
down arm places on
the scooter. The scooter
can fall off the lift if not
properly secured.
caUtIoN!
Drive the scooter off
in REVERSE. When the
scooter is clear of the
platform, raise the
platform by pushing up
on the UP/DOWN switch.
maINteNaNce
This Outside Lift is designed to be as trouble free as possible;
however, some basic maintenance will ensure that it continues
to offer reliable use for years to come.
Oil pivot points on all moving parts every 30 days.
Re-grease the inside vertical square tube every 30 days in
winter or in dirty or dusty conditions. Just lower the platform
to the ground and clean the tube with mineral spirits, WD-40,
or a good solvent. When clean, grease the square vertical tube
shaft with high grade water-resistant grease such as boat trailer
wheel bearing grease.
[Figure 12-1]
Check for paint chips and touch up bare metal. Use a good
gloss black enamel or lacquer to inhibit rust. You may need to
do this more frequently if your lift is subject to salt air or road
salt in the winter.
Figure 12-1
Summary of Contents for AL010/050
Page 62: ...900 62 Notes ...
