Harmar Mobility Helix CSL500, Owner'S Manual

Helix Curved Stair Lift:

 Owner’s Manual

26JUNE19  |  610-00039-01 REV C

5

HELIX CURVED STAIR LIFT

OPERATIONS

POWER SUPPLY

The stair lift should be kept fully charged at all 

times. When the lift stops at an upper or lower 

landing it will charge automatically. The charger 

should be left plugged in at all times and the lift 

may be left on charge indefinitely. A green light 

indicates the supply is on.

REMOTE CONTROL

Your Remote Control allows you to move your 

Stair Lift from its parked position. Just press the 

up or down button for the desired direction. 

Keep the button pressed until the lift reaches its 

final position and stops automatically.

MID LEVEL PARKING

When the unit comes in contact with the mid-

level charger, it will stop for about 3 - 5 seconds. 

If you release the remote or toggle it will charge 

at that location.

OPERATION

1. 

Fold down the armrests and seat before 

using the lift.

2. 

Tighten seat belt.

3. 

Start the run by using the rocker button 

on your arm rest, push the rocker button 

in the direction you want to ride and 

maintain pressure until the lift reaches its 

final position and stops automatically.

4. 

Use the seat swivel handle to turn the 

seat to dismount after it has reached the 

final stop (top position). It is now possible 

to fold up the foot support, seat, and 

armrests to save space.

Controls

Emergency Safety 
(Optional)

Key Lock (Optional)

Power Switch (Circuit 

Breaker)

Status Light 
- Red = Major Fault 
- Yellow = 
Obstruction 
- Green = Ready

Power On Light

Charging Light 

Test/Diagnostic Port 
This port enables 
you to connect a PC 
to the unit to check 
several functions. 

Before using the remote, always check that 
no one is in the process of getting on/off. The 
remote can move the unit when it is not in 
sight. 

WARNING

!

Always use the seat belt when using your lift. 

WARNING

!

NOTE: When the Stair Lift stops in the parked 

position, ensure that the charger light is lit. 

It indicates the lift has stopped in the correct 

charging position. 

NOTE: A seat swivel locking device on the seat 

prevents the lift from being operated unless the 

seat is in its operating position.