| www.harmar.com | 800-833-0478
8
© 2018 Harmar Mobility, LLC • All Rights Reserved
Install set screw, that holds seat from coming up, in collar where the wires for the hand control comes
through.
[Figures 8-1, 8-2].
Connect seat rocker switch wires.
[Figures 8-3, 8-4]
10. Chassis Load
Roller position-Ensure charging point
[Figure 8-5]
is on the top.
Using the loading bar,
[Figure 8-6]
slide on until drive hits the gear rack.
Activate the rocker
[Figure 8-7]
to drive onto rack, watching the wheels to ensure they go on smoothly.
Ensure the unit goes down the gear rack about 6".
INSTALLATION
NOTE:
Lubricate seat post before installing using a white lithium grease.
Figure 8-1
Figure 8-2
Figure 8-3
Figure 8-4
Figure 8-5
Figure 8-6
Figure 8-7
