Step 4
Whether the enclosure uses a fixed ramp or you
have a pit or have built your own ramp, the next
step is to adjust the height of the doors or gates
to fit their thresholds. Pry them gently to the
correct height with a piece of wood to prevent
damaging the finish. Check that the doors or
gates are properly centered on the platform,
then tighten the bolts. When you get the height
right, you may need to fine-adjust the lower and
upper stops on the lift to get it to stop in exactly
the right place,
Step 6
You can adjust the upper and lower limit switches to
make the lift stop exactly where needed.
Sometimes it comes from the factory right, so this
isn’t required.
Step 5
You have received one piece of Plexiglas that
isn’t installed in any frame, even if you have an
enclosure with metal panels. You will saw this
piece to fit exactly in the space that’s left above
the door after you’ve adjusted the height.
Measure the vertical height carefully, then mark
the desired width on the plex. Place it on saw
horses and clamp a long straight-edge to it,
adjusted for the specific circular saw you plan to
use. With a sharp blade, moving slowly, you
can saw the acrylic. Install the acrylic with
the angles and flats provided, which rivet in.
10
