SL300 PINNACLE STAIRLIFT:
Install Manual
26MAY2022 | 630-00100 J
13
INSTALLATION
PINNACLE STAIRLIFT: SECTION 4
5. Install the end plate to the top of the track
with the four (4) self-cutting Torx screws using
the supplied T30 Torx bit. Making sure not to
pinch the wires on the pigtail
.
Too much torque applied to these screws may result
in damage. Take your time and apply Lithium grease
to threads.
NOTICE
6. Install one of the rack pre-compression screws
in the threaded hole in the top plate of the
rail, and tighten it as firmly as possible by
hand with a 5/32" Allen wrench. Make sure to
use the 1 1/4" pre-compression screw.
See Figure 4-22.
Figure 4-22
7. Plug in the power supply at either end of the
rail, depending on the closest or most
convenient location of a wall power supply.
Minimize wire length and intrusion.
Use care in routing the charger lead. If possible,
secure along or inside wall to avoid the creation of
a tripping hazard.
WARNING
!
FOOTREST AND SEAT
INSTALLATION
1. Use the installation switch to drive the chassis
down to the bottom step. This will provide a
safe area to install and adjust the footrest. Do
not drive the unit into the bottom stop.
2. Turn the red "On/Off" switch located on the
top of the chassis to the "Off" position.
3. Remove the four (4) screws holding the
vertical seat support shroud in place with a
Phillips screw driver and set aside.
4. Position the footrest onto the two (2) seat-
leveling bolts on the outside of the chassis by
aligning the large opening at the slot ends of
the footrest.
See Figure 4-23.
Figure 4-23
NOTE: Harmar recommends using a torque wrench and
setting the footplate bolts to 25ft lb. both front and
back of the chassis.
See Figure 4-24.
Figure 4-24
