SL300 PINNACLE STAIRLIFT:
Install Manual
26MAY2022 | 630-00100 H
20
INSTALLATION
PINNACLE STAIRLIFT: SECTION 4
Figure 4-44
11. Adjust the height of the two feet using a 9/16"
open end wrench. Set them so that both rest
on the floor with the rail fully straight. The
foot furthest from the wall should be set a
little taller than the inside one to get it to sit
flat on the floor, since the Pinnacle rail
brackets intentionally lean the rail toward the
wall.
See Figure 4-45.
Figure 4-45
12. Reinstall the two (2) plastic caps on the feet to
cover the threads.
See Figure 4-46.
Figure 4-46
13. Carefully move the fork with your hand to
make sure it operates smoothly. Allow it to go
all the way to the floor. Confirm that both feet
sit level on the floor and the hing-joint is fully
straight.
See Figure 4-47.
Figure 4-47
14. Follow the normal procedure for installing the
rail brackets and tighten them.
See page 9, step 8.
15. Test ride the unit a couple of times to verify
that the folding rail is operating properly.
Be careful not to pinch your fingers when moving
the fork.
WARNING
!
