Pinnacle HD Stair Lift Manual |
| www.Harmar.com | 866-351-2776
16
P/N: 75403 RevB 72618
Completion Procedures
E. ADDITIONAL SYSTEM CHECKS
STEP 1: After the successful testing of all safety switches, sit on the lift and operate to the top of the stairs.
Keeping the control switch depressed continuously, the lift should gently decelerate and then stop at the top of
the track.
STEP 2: As a final adjustment, sit on the lift and do two (2) complete up trips and stop with the chair at the
bottom. Then tighten the compression screw in the top end plate, then run the chair to the top and again tighten
the compression screw. Run the chair to the middle and do a final tightening of the compression screw.
STEP 3: Drive the lift to the bottom, keeping the control switch depressed all the time, and check that the lift gently
decelerates and stops so the footrest pan is clear of the floor. If necessary adjust the limit cams with a 5/64” Allen
wrench.
STEP 4: Move the lift about three (3) feet from either the top or bottom of the rail. After 30 seconds the armrest
LED indicator light will show orange and beep indicating that the lift is not positioned on a charge point. The
beep will stop after 30 seconds, but the armrest LED indicator light will continue to flash orange.
STEP 5: Test the seat swivel at the top by using the levers and swiveling the seat towards the landing and stop
the seat at 35 and 85 degrees. The seat swivel levers will release into a locked position at each of these angles.
The lift will not operate in any of these positions if the control switch is depressed, and the LED indicator light will
turn orange. Return the seat to its normal position and the LED indicator light will turn green and the lift will now
operate normally.
STEP 6: Drive to the top or bottom and check the battery charging light. If the light is orange or red, the batteries are
being charged.
THE LIFT IS NOW READY FOR USE.
