Pinnacle Stair Lift Manual |
| www.Harmar.com
6
Stair Lift Operation
Step 3: Ensure that you are securely seated before operating the lift. To operate the lift, continuously press the
hand control switch on the side in which you wish to travel.
CAUTION! Keep your feet centered on the footrest while traveling up and down the stairs. Never dangle
your feet off the footrest while riding the lift.
Step 4: If you release the control switch the lift will stop. Continue to press the switch or button all the way to
the landing. The lift will gently stop at the appropriate, preset point.
Step 5: To safely exit the lift, support yourself by the armrests, rise and step off the footrest. At the upper
landing, ensure that the seat is fully swiveled and locked before rising. If you do not intend to use the lift again
immediately the seat and armrests may be folded up to minimize obstruction to people walking on the stairs.
CAUTION! Use the armrests to assist you when getting on and off the lift.
Step 5: To operate the lift remotely, continuously press the appropriate up or down button on the call/send
hand control unit. These hand control units are usually attached to a wall at the upper and lower landings of
the staircase. Like all infrared devices, the signal may be interrupted if the hand control unit is not in the line
of site of the stair lift. If this happens the lift may temporarily stop but restart immediately, as long as the hand
remote is pressed continuously.
If you are operating the lift remotely on behalf of another person, please ensure that they are securely
seated with the seat belt engaged. Always keep the person in line of sight before commencing movement.
NOTE: An orange light and single beep indicate that the lift has touched an obstruction and may only be
operated in the opposite direction of the obstruction. Clear the obstruction before proceeding.
If the light flashes orange and the lift beeps intermittently, the lift has been stopped away from the top
or bottom charging stations. Please move the lift to either end of the rail to ensure the batteries remain
fully charged.
The LED indicator light will turn red if there is a service issue. Turn the “ON/OFF” switch to the “OFF” position
(O) and then back to the “ON” position (I). The lights should sequence red-orange-green. If the light does not
return to green, please call your service representative.
