P/N: 76015 RevE 72618
SL600 • Pinnacle Stair Lift Installation Manual
5
Pinnacle Stair Lift
INSTALLATION PROCEDURES
B. RAIL INSTALLATION
1: Open the rail box and remove the contents.
2: Position the bottom rail (the rail with end plate
attached) directly on the stairs with the end plate
towards the bottom of the stairs and the plastic rack
facing up. Place an object that measures between
1/2" between end plate and the floor.
[Figure 5-1 and
5-2]
3: Position the two ends of the rail close together.
Locate and connect the plug on the ends of the two
power harnesses inside the two rail pieces.
[Figure 5-3]
4: With the plastic rack facing up, slide the top
rail into the bottom rail and guide them together
using the pre-installed pins. Gently tap the top rail
if necessary to get them close together. Be cautious
not to pinch the power harness.
[Figure 5-4]
5: Install two (2) joint fasteners and firmly tighten
with 3/16
"
Allen wrench. Then slide rack pieces
down to cover joint.
[Figure5-5]
6: Turn over joined rails and install the remaining
two (2) joint fasteners and firmly tighten with 3/16
"
Allen wrench. Then slide rack pieces down to cover
joint.
[Figure 5-6]
7. Install rail brackets with label facing the wall by
loosening the screws and snapping each bracket
edge into the slot, or slide the brackets on from the
top of the rail.
[Figure 5-7]
Figure 5-1
Figure 5-6
Figure 5-5
Figure 5-4
Figure 5-3
Figure 5-2
Figure 5-7
TIP
Use the chair box or another heavy object, like a toolbox, at
the bottom to prevent the rail from sliding down the stairs.
TIP
The brackets are tightened from one side only. It is important
that the bracket be installed with the nut side facing the wall
so when the rail is turned over to its correct orientation the
screws will be accessible.
