Harmar Mobility UP STAIRLIFT, Owner'S Manual

UP STAIRLIFT:

Owner’s Manual

28JULY2023  |  630-00160-A

15

OPERATION

UP STAIRLIFT: SECTION 3

JOYSTICK

EMERGENCY STOP

In case of an emergency while driving the stairlift, 

either release the joystick or press the on/off button 

once. The on/off button will force the brake to 

activate and stop the stairlift. 

NOTE: When accidentally pressing the start button or to 

remove the emergency stop, press the start/emergency 

button again. This will release the brake and the stairlift 

will be able to move again.

POWER-DOWN MODE

The stairlift can be powered down by folding the 

armrest up and holding the on/off button.

WI-FI AND VOIP

To use the emergency warning device, hold the 

emergency button for 10 seconds. The stairlift 

will attempt to connect to the network and send 

emergency data. After the emergency data has been 

sent, the stairlift will attempt to call the stairlift 

dealer. To cancel the call, hold the emergency 

button for 4 seconds. 

NOTE: The Wi-Fi and VoIP functionality can only be used if 

the technician configured the stairlift to do so. The Wi-Fi 

and VoIP functionality is meant as an assistance tool in 

case of an emergency and its stability depends on the 

configured Wi-Fi network. 

REMOTE CONTROL

A remote control can be used to either bring the 

stairlift up or down the rail with or without the user. 

1. 

Press the joystick (like a button) to activate 

the remote control until the LED lights up. 

2. 

Shift the joystick up to drive the stairlift up 

the rail. 

3. 

Shift the joystick downwards to drive the 

stairlift down the rail. 

NOTE:  If the stairlift is not on the charger for more 

than 30 minutes, it goes into deep sleep to prevent 

the batteries from draining. As a result, the remote 

controls and Bluetooth connection no longer work. 

This can happen when the lift is not on the charging 

point, but also when the lift is on the hinge rail or 

the charger is not connected. Pressing the on/off 

button on the armrest will turn off deep sleep and 

both the lift and remote controls will work again.