Chapter 3 Cabling
Establishing Ethernet Connection
© 2011 Harmonic Inc.
32
bNSG 9000 & NSG 9000-3G, Rev D
.
NOTE:
The above Power Up screen is of NSG 9000 narrowcast firmware. For bNSG 9000 broadcast
firmware, the title is "Harmonic bNSG9K".
CAUTION:
Once you power up the device, the QAM-RF ports should always be connected as explained
in
3.3 Connecting the QAM-RF Output Cables
on page 30 or else terminated.
NOTE:
The unit may have more than one power supply cord. To protect against electric shock, disconnect
all power supply cords before servicing.
3.8 Establishing
Ethernet
Connection
Because the NSG 9000 is configured and controlled by a remote management system, you
must set the IP addresses of the Ethernet ports located on the back panel of the NSG 9000.
For further information, see for NSG 9000, NSG 9000 Software User’s Guide and for bNSG,
bNSG 9000 User’s Guide.
NOTE:
The NSG 9000/bNSG 9000 requires a user name and password to log in to all management
interfaces, including the serial communications console, web client and FTP. Both user name and password
are
configure
.
3.8.1
What’s Next...
The next step is to set preliminary configuration to the NSG 9000/bNSG 9000, as described
in the
NSG 9000 Software User’s Guide
and in the
bNSG 9000 Firmware User’s Guide
,
respectively.
