Chapter 5 Video Configuration
© 2013 Harmonic Inc. Harmonic All rights reserved.
122
Ellipse 3000 Release 3.0, Rev. B
Ancillary Data Sub-Menu/Box
5.2
Ancillary Data Sub-Menu/Box
Front Panel
To access the
Ancillary Data
sub-menu on the front panel:
❖
Navigate
Root > Configuration > Video > Video > Ancillary Data
.
Web Manager
Figure 5–5: Ancillary Data box
Use the
Ancillary Data
sub-menu or box to display or configure the following parameters:
■
Aspect Ratio Source
– Options:
❑
Manual
– (Default)
❑
WSS
– Aspect ratio is drawn from the Wide Screen Signaling (WSS) sent with the video input
signal. When this parameter is set to WSS, the
Aspect Ratio
parameter displays the values
Auto 4:3
and
Auto 16:9
instead of
4:3
and
16:9
.
❑
AFD
–
■
Aspect Ratio
– Use the
Aspect Ratio
parameter to set the aspect ratio. The options are:
❑
4:3
– Aspect ratio is manually set to 4:3. (Default)
❑
16:9
– Aspect ratio is manually set to 16:9.
❑
Auto 4:3
– Aspect ratio is drawn from the WSS signal. When no WSS is detected, the aspect
ratio is set to 4:3.
❑
Auto 16:9
– Aspect ratio is drawn from the WSS signal. When no WSS is detected, the aspect
ratio is set to 16:9.
■
AFD Bar Data
– Use this parameter to manage the insertion of bar data from the AFD to the
encoded streams. Configurable for SDI input only. Options:
❑
Insert
❑
Discard
(Default)
