Chapter 2 Initial Configuration and Basic Opera-
tion
© 2013 Harmonic Inc. Harmonic All rights reserved.
29
Ellipse 3000 Release 3.0, Rev. B
Ellipse Set-Up Procedures
2.2.1
H.264 Ultra Low Latency Mode Set-up Procedure
The receiving IRD should be set to
Ultra Low
latency mode. If the IRD receives IP stream from the
Ellipse, the IRD de-jitter buffer should be set to minimum.
To set-up the Ellipse to receive and process an ultra low latency H.264 transport stream:
1. Select
Unit > Video
in the web manager.
2. Select
Sync to Video
in the
Sync Mode
pull-down menu.
3. Select an H.264 profile under
Codec Profile
.
4. Select
Ultra Low
in the
Latency Control
pull-down menu.
5. Press
F1
on the front panel to save the new service (refer to
for configuration save instructions).
