Omneon, Now Part of Harmonic
29
Replacing an I/O Module
To attach the new I/O module to existing players:
1. Open the
Player List
for the Omneon MediaDeck, and then click
the
Edit
link for any player that will use the new I/O module.
Tip:
To open the Player List, click the
Player Configuration
icon in the
left-hand column, and then click the icon for your Omneon MediaDeck.
2. For each track, click the
Attach Devices
button (within each track
section) to display the
Attach Devices
page as shown in
.
Figure 14 Attach Devices Page
3. In the
Attach
column, click the check box for the device (Omneon
MediaDeck Module) that you wish to connect, and then click
Done
.
The
Edit Player
page appears. The ID of the new I/O module will
appear (in the following format: MDM-5001_XXXXX) next to the
attached tracks.
NOTE:
For help with modifying settings on either the Edit Player page or
the Attach Devices page, refer to “Creating a Player” in the
SystemManager User’s Guide
.
4. Click
Done
to return to the
Player List
page.
5. Repeat steps 1-4 for each player that uses the new I/O module.
Summary of Contents for Omneon MediaDeck
